Bosch 0 607 561 114 Handbuch Seite 24

After the bevel has been rough adjusted, snug down
the locking screw 29 until it is still just barely possible
to shift the footplate 10. Adjust the bevel precisely.
Bevels of 0°, 15°, 30°, and 45° are indicated with
markings on the bevel scale 28 Intermediate adjust-
ments are also possible. For exact bevels, you should
employ a protractor 30. Tighten the locking screw 29
by using the Allen wrench 3.
You can adjust the 0° position (saw blade perpendic-
ular) by sliding the footplate 10 toward the rear of the
tool until it is caught in a detent notch 27. Slide the
footplate 10 in the direction of the motor against the
detent notch 27 and tighten the locking screw 29.
Flush Cutting
For flush cutting, you can reposition the footplate 10 to-
ward the back of the tool:
Completely unscrew the locking screw 29 in the coun-
terclockwise direction by using the Allen wrench 3,
which is located in the footplate 10. Lift up the footplate
10 and reposition it toward the back of the tool so that
you can screw the locking screw 29 into the rear thread
31. Tighten the locking screw 29 at first only slightly,
slide the footplate 10 in the direction of the saw blade,
and then tighten the locking screw firmly.
Flush cutting can be performed only with a per-
pendicular saw blade (0° position). It is not pos-
sible in this case to use the parallel guide with cir-
cle jig 34.
3 609 929 250 • (04.07) T
Note: For easier cutting in very tight places, you can
remove the barrel grip 2:
Push the orange-colored SDS blade change button 1
downward over the locking point and simultaneously
pull the barrel grip 2 upward away from the tool.
To reinstall the hand grip:
Push the SDS blade change button 1 upward into the
initial position. Set the hand grip 2 back in place and
press it downward with (if needed) a slight twist until
you hear it lock in place.
Parallel Cuts
27
31
3
29
10
You can make parallel cuts up to a material thickness
of 30 mm (1.2 inches) by using the parallel guide with
circle jig 34.
Loosen the locking screw 33 and slide the scale
through the cutting guide slot 32 in the footplate 10.
Slide the scale through the cutting guide slot as far as
needed for the separation of the parallel cut. Use the
scale value on the inner edge of the footplate as your
guide. Parallel cuts of up to 20 cm separation are pos-
sible. Tighten the locking screw 33 at the desired
scale value.
English–10
1
2
34
33
32
10