Checking After Installation - Sony BL55-RU Bedienungsanleitung

2
Lift up the slider holder over the scale unit.

3-4-5. Checking after Installation

Once the scale is installed, check the installation state. Use the slider holding plate of the slider holder as a
checking tool.
1
Separate the slider holder removed in section 3-4-4 into the spring holder and slider holding plate.
2
Check that the rib section of the slider holding plate fits smoothly into the space between the scale unit
and slider. (Thickness of the rib section of the slider holding plate: 1 mm)
The scale and slider were not attached properly if the slider holding plate does not fit or rattles noticeably.
The scale and slider must be attached again from the beginning.
3-8
(E)
Fig. 3-10
Spring holder
Fig. 3-11
Slider holding plate
Rib
Fig. 3-12
Slider holder
Slider holding plate
BL55-RU