Removing The Slider Holder - Sony BL55-RU Bedienungsanleitung

Mounting brackets to the slider top
Mounting bracket
Align the slider top and mounting bracket, and adjust the mounting bracket so that the distance from the
alignment surface is 19 ± 0.1 mm. Make the parallelism and flatness of the alignment surface as shown in
Table 3-2.
Washer/Nut: .......................... Plain washer with nominal size 4: 2 washers/Hex. nuts with nominal size 4: 2
Screw/Tightening torque: ..... M4 x 25: 2 pcs. / 2.7 N . m

3-4-4. Removing the Slider Holder

Remove the slider holder after attaching the slider.
The slider holder can be removed from the slider with a one-touch operation.
There is a protrusion on the scale unit side of the slider. The slider holder fits into this protrusion. Use the
following procedure to remove the slide holder.
1
Pull out the slider holder in the lengthwise direction so that the protrusion on the scale unit side is passed
over, and then separate the slider and slider holder.
Scale unit side
BL55-RU
Fig. 3-8
nuts
Protrusion
Fig. 3-9
Scale unit
Slider unit
M4 nut
19 (0.748") ±0.1 (0.004")
Scale unit side
Unit: mm (inch)
3-7
(E)