Activating/Deactivating The Button Tones; Activating/Deactivating Eco Mode; Setting The Rain Sensor; Setting The Mowing Program - Kärcher RLM 4 Betriebsanleitung

NOTE
Further menu items: see chapter 5.2
"Making the basic settings", page 52.
7.2

Activating/deactivating the button tones

* Key clicks
1. or
2. Activating/deactivating the button tones:
■
Activate
or
Activate the button tones.
■
Deactivate
or
Deactivate the button tones.
7.3

Activating/deactivating Eco mode

In Eco mode, the appliance switches to energy-
saving mode. This reduces the energy consump-
tion and noise emissions.
NOTE
With high and thick grass and for thick
rolled turf, this is not recommended or
may not be possible.
* EcoMode
1. or
2. Activating/deactivating Eco mode:
■
Activate
Activate Eco mode.
■
Deactivate
Deactivate Eco mode.
7.4

Setting the rain sensor

NOTE
Mowing when the grass is dry reduces
soiling.
By activating the rain sensor and setting
a delay time, it is possible to prevent the
appliance mowing when the grass is
wet.
If the rain sensor is activated, the appliance
moves back into the charging station when the
rain begins. It remains there until the rain sensor
has dried. Then it waits for the time period that is
set as the delay before it continues mowing. The
sensitivity of the rain sensor is adjustable.
* Rain sensor
1. or
2. Activating/deactivating the rain sensor:
■
Activate
or
Activate the rain sensor.
■
Deactivate
or
Deactivate the rain sensor.
54
:
:
:
:
:
:
3. Setting the delay of the rain sensor:
■
or
■
xx hours xx minutes
Select the required value for the delay
with or
4. Setting the sensitivity of the rain sensor:
■
or
■
Select the required value for the sensitivi-
ty with
7.5

Setting the mowing program

7.5.1 Setting the mowing program – General
1. Call up the main menu with
* Programs
2. or
3. Select the menu item with
cept with
4. Carry out the settings.
Note: The menu items are described in the
following sections.
7.5.2

Setting entry points

Learning entry points
1. Place the appliance in the charging station.
2. Switch on the appliance with
3. Call up the main menu with
* Programs
4. or
* Entry Point
5. or
* Interactive teach
6. or
* Start interactive entry
7. or
point teaching
■
or
moves along the boundary cable.
■
or
has reached the required entry point. The
entry point is stored.
Set entry point 1
8. or
entry point has been specified during the
teaching-in movement. If no entry point has
been specified here, the entry points are au-
tomatically specified.
Entry point x: XXm
9. or
last entry point has been reached.
GB
* After rain delay
and accept with
* Rain sensitive
or and accept with
.
or
.
ON
.
OFF
.
:
Start
. The appliance
Set
when the appliance
.
.
and ac-
if no
if the
RLM 4