Designated Use - Endress+Hauser Prowirl 72 Einbauanleitung

EA01085D
1.1 Pressure test after sensor replacement
NOTICE
‣
It is generally advisable to perform a pressure test after replacing the sensor. The pressure
test is required for devices which were delivered with the PED or pressure test certificate
option.
2

Designated use

The spare part sets and Installation Instructions are used to replace a faulty unit with a
functioning unit of the same type. Only original parts from Endress+Hauser may be used. As a
matter of principle, only spare part sets that Endress+Hauser has intended for the measuring
device may be used.
Perform the check via W@M Device Viewer. The procedure to be followed is described below.
Some measuring devices contain an overview of spare parts inside the device. If the spare
part set is listed in this overview, there is no need to check the set.
1. www.endress.com/deviceviewer
2.
Ser. No.: 12345
6
Order code Description
3.
=
?
4.
1. www.endress.com/deviceviewer
2. Enter the serial number (ser. no.), search for the
product data and click spare parts.
3. All the spare parts for the measuring device are
displayed.
4. Determine the order number for the spare part set.

The spare part set may only be used if the order
number of the spare part set matches an order
number in the list of spare parts.
Endress+Hauser