Inhaltsverzeichnis
Werbung
The image of the camera appears on screen and you
can hear the sound recorded by the camera.
If, contrary to all expectations, no image appears
on screen or another failure occurs, immediately
switch off the operating voltage, switch off the
TV/monitor and check the device for failures
according to the check list "Troubleshooting" in
this operating manual.
If the image is not well-defined,
you can adjust the definition by
turning the objective (first ring).
Via switch (10) you can switch
on/off the automatic exposure
time. The back-light compensa-
tion can be switched on/off by
means of switch (11).
It is recommended to leave the switches in posi-
tion ON (AES and BLC).
28
To adjust the camera
mage, you can align
the support vertically
or
horizontally
releasing the screws
(5).
To obtain a greater distance to the wall, use the
spacer (4).
Use the drilling holes of the base plate (3) as drilling
template.
Make sure that there are no electric lines,
water conduits etc. at the intended drilling
holes.
Fasten the base plate (3) with the enclosed screws.
Use dowels, if necessary.
Use a suitable screwdriver.
Fasten the thread (1) of the camera at the camera sup-
port with screws and fix the screw joint with the nut (6).
by
25
Werbung
Inhaltsverzeichnis
Fehlerbehebung
