28 Smart Diagnosis - LG VR64701LVMP Bedienungsanleitung

Robot Cleaner uses this Smart Diagnosis feature to run a self-diagnosis.
If any irregularity is found from the diagnosis, please contact the local LG Electronics
service center.
During Smart Diagnosis, the Robot Cleaner will move about within a 50
objects are in the way within a 1
1. Smart Diagnosis will operate when the main power switch
of the Robot cleaner and the Home station are turned on,
and the unit docked on the Home station.
Smart Diagnosis is only possible when the Robot
Cleaner is attached to the Home Station.
2. Press 'Diagnosis' button on the Remote Controller, then
the process will start with a voice message which says
"Robot Cleaner smart diagnosis will be started. Please
step away and clear around 1 meter around the home
station."
If the Mop Plate is attached, the process will not be
activated.
3. When the Smart Diagnosis has successfully
fi nished, Robot Cleaner will return back to the
Home Station and inform the result through a
voice message. After the voice message, pressing
the 'HOME' button on the Remote Controller
or main unit will allow the voice message to be
repeated. To terminate the diagnosing process,
press the 'Stop/OK' button on the Remote
Controller or main unit.
After the Smart Diagnosis voice message,
the Robot Cleaner will start recharging after
1minute.
If an error is detected with any of the Sensors
whilst in Smart Diagnosis, a voice message will
announce, and the unit will not return to the
home station.
Tip
• Be careful not to touch the Robot Cleaner or disturb its operation before Smart Diagnosis
is complete. If it is accidently interrupted, turn the main power switch OFF then ON again to
resume the diagnosis.
• Smart Diagnosis will not be activated in each of the following cases. In each case, check the
problem and try again.
- Robot Cleaner is detached from Home Station
- Battery level is insufficient
- No Dust Bin Filter is fitted.
- Mop Plate is attached
radius around the Home Station, before starting Smart Diagnosis.
SMART DIAGNOSIS
radius. So, make sure no
27