Intended Use; Before First Use; Start-Up - Westfalia 80 83 31 Bedienungsanleitung

Intended Use

The compressed air metal shears are intended for cutting sheet metal without
deforming the material and are suitable for straight cuts and cut-outs. The
metal shears are not designed for cutting in narrow curves.
The intended use also includes an operation following the operating
instructions.
Any use beyond these parameters (different media, applying force) or any
changes (reconstruction, no original accessory) can lead to serious risks and
is regarded as use that is contrary to the intended purpose.

Before first Use

Unpack the compressed air metal shears and the accessory and check all parts
for damage in transit. Dispose of packaging materials or store it out of reach of
children. Plastic bags etc. may become a deadly toy for children.

Start-up

The compressed air metal shears are equipped with an R ¼" air inlet (5). For
your own safety it is not recommended to use a permanent connection
between the metal shears and the air hose, but use the supplied quick
coupling adaptor (6) instead.
Seal the end of the quick coupling adaptor with Teflon tape before you screw it
on the air connection of the metal shears.
The air tool has to be provided with lubricating oil during operation. Before
each use add oil through the air fitting or use an oil-fog lubricator. Also read
the chapter Lubrication.
Use a flexible hose to connect the compressed air metal shears to the
compressor. Switch on the compressor.
Set up a pressure of 6 bar on the compressor. Check all air connections for
leakages.
Hold the metal shears firmly with both hands. Press the trigger (3) and slowly
move the metal shears along the workpiece. Do not use force when pushing
down the metal shears against the workpiece. If you are not satisfied with the
result, check the blade insert (1) for wear.
First disconnect the tool from the air supply when not using the unit, after
finished working and when applying maintenance work. Press the trigger in
order to remove any remaining air from the compressed air metal shears.
Operation
10