Operation
Before using the unit, please read the included safety notes for your own
safety.
Charging the Screwdriver
Before the first use, the screwdriver must be charged. Connect the screwdriver
to the charger. The charging socket (9) is located in the rear part of the
housing. After that, connect the charger to a wall outlet. Please confirm that
your local mains voltage corresponds to the operating voltage stated on the
type label. During charging, the red control LED (8) located on the handle,
lights up. When the charging process is complete, the light turns off. Normally,
3-5 hours are sufficient to fully recharge an empty battery.
Working with the Cordless Screwdriver
Inserting Tools
The screwdriver is equipped with a bit holder (1). Use the magnetic bit holder,
to connect hex sockets, use the ¼'' square connector.
When selecting a bit, please make sure the bit fits the screw. Insufficient
power transfer can lead to the destruction of both bit and screw.
Operation
Turning ON/OFF and Reversing the Rotation
Use the ON/OFF switch (7) to turn the unit on and off and use the rotating
direction switch to set the rotating direction of the screwdriver. If you slide the
switch to the right, the screwdriver rotates counter clockwise and red LED
lights up, if you slide the switch to the left, the screwdriver rotates clockwise
and the green control LED lights up.
4