Cleaning And Care - Klarstein 10031190 Gebrauchsanweisung

Function setting
Press FUNCTION button to select ANION, OZONE or both of them. The LED shows as below:
UV ANION OZONE
• Ozone is an optional function .
• People should keep away after turning on ozone .Ozone will stop working and change to Anion function
after 1 hour working.
• HEPA, Activated carbon & Photo catalyst are the basic functions, it is working when you turn on the unit.

Cleaning and Care

• Do not clean the unit with water.
• If you are cleaning with scour, please dilute the scour before use.
• Do not clean the unit wtth the solvent listed on the right which may cause distortion or depigmentation.
• If clean with chemical solvent, please read its cautions carefully before use.
Cautions for replacement of UV lamp
When the symbol of UV is flashing, it reminds you to replace the UV lamp.
1 2 3 4
1 Take off the right cover and take out HEPA filter.
2 Hold the UV lamp and rotate ii clockwise or anticlockwise for 90°, then take it out.
3 Hold the UV lamp and install the 2 sides of UV holder, then rotate it clockwise or anticlockwise for 90°.
4 Put in the HEPA filter and install the right cover.
14