Before First Use; Tool Fitting; Initial Operation - Westfalia 53 34 30 Bedienungsanleitung

Before first Use

Unpack the mini drill and milling machine and check all parts for any damage in
transit.
Dispose of packaging materials or store it out of reach of children. Plastic bags
etc. may become a deadly toy for children.

Tool Fitting

1. To insert a tool e.g. a steel cup brush (7), press the axle locking pin (5). Then
turn the locknut (6) anticlockwise to loosen. Use the key provided (8).
2. Push the selected tool into the chuck as far as it will go and tighten the
locknut (6) again firmly, while holding down the axle locking pin (5). Use the
key (one of the three different-sizes 2.4 mm, 3 mm or 3.175 mm) that
matches the corresponding diameter of the tool bit.

Initial Operation

1. Ensure that the ON/OFF switch (2) is switched off.
2. Then connect the plug to the power socket.
3. Switch the machine on by switching the ON/OFF switch to the "ON" position.
The unit will now start up. The LCD display initially shows the number "5",
which corresponds to the start-up rotation speed of 5 x 1000 revolutions/min
= 5000 revolutions/min. The number displayed in the LCD screen always
shows the rotation speed in units of 1000 revolutions/min.
The rotation speed is adjustable between 5 up to 32 (5,000 revolutions/min up
to 32,000 revolutions/min).
4. To adjust the rotation speed press the "+" button (3). Similarly, the rotation
speed can be decreased with the "-" button (4) in steps of 1000
revolutions/min. The rotation speed can also be adjusted while the machine is
running.
Using
6