Inserting And Replacing The Blades - Westfalia 82 54 74 Bedienungsanleitung

Inserting and replacing the Blades

Before working on the cutting blades, always wait until the grass trimmer has
come to complete standstill after switching off.
1. Remove the battery from the grass trimmer!
2. Turn the grass trimmer upside down.
3. Grasp the blade holder. Insert the cutting blade aligning the big side of hole
onto the pin of the blade holder. Then push the blade as far as possible to
the right so the taper part of the hole is held by the blade holder (figure 1).
4. Install the second cutting blade in the same fashion.
5. Re-insert the battery.
For removing the cutting blades, grasp the blade holder and push the cutting
blade to the left. The lift it up and remove it from the blade holder (figure 2).
Note:
When a cutting blade gets blunt, simply turn it around 180° so you can use the
other cutting side of the blade.
Operating
25
Fig. 1
Fig. 2