Westfalia 85 93 52 Bedienungsanleitung Seite 29

1. Install the adapter (a) for sharpening plane blades and chisels on the multi
task sharpener.
2. Put the blade or the chisel on the support blade (figure 3a). The mag-
net (n) keeps the material to be processed in its place.
3. The angle between the material to be processed and the grinding disc must
correspond to the original angle at the cutting edge of the material to be
processed (figure 3b).
4. The sharpening angle can steplessly be adjusted from 20° to 40°. To do so,
untighten the angle adjusting handle (o) counter clockwise and tilt the
support plate to an appropriate angle. Then tighten the angle adjusting
handle again (figure 3c). Important: Do not set up an angle wider than 40°
in order not to damage the transparent finger guard (m).
5. The cutting edge of the material to be processed may touch the surface of
the grinding disc only slightly.
6. Use the on/off switch (b) to put the multi task sharpener into operation.
7. Press the material to be processed slightly against the grinding disc and
move the support plate and the material to be processed evenly back and
forth all the time, otherwise the cutting edge would be sharpened unevenly
(figure 3d).
8. When sharpening, move the material to be processed along the support
plate further downwards and continue moving it from side to side
(figure 3e).
9. Switch off the multi task sharpener.
10. Check whether the cutting edge angle is sharpened properly (figure 3f).
Check whether the material to be processed is sharpened sufficiently and
repeat the sharpening process if necessary.
11. Use the provided distance piece (p) to sharpen thin chisels (figure 3g).
12. After sharpening, grind the cutting edge using an oil stone or the like.
Important Notes
 The work piece may become very hot during sharpening / grinding. This
may lead to a change in the material properties of the work piece.
Therefore, allow the work piece to cool down during machining.
 Do not operate the multi task sharpener longer than 15 minutes. Then allow
it to cool down for at least 30 minutes.
 If the sharpening results are poor, check the grinding disc for wear and
replace it if necessary.
Operation
25