Endress+Hauser Promag 400 Index C Einbauanleitung

EA0199D/06/A2/01.13
71242228
Installation Instructions
Replacing the electronics
Promag 400 Index C
Instruction is valid for the following spare part kits:
Order number Device component
Kit electronics module
complete Promag 400 C
Kit power supply
XPD0014-
Kit I/O-board
Kit amplifier
NOTICE
• The order number of the spare part set (on the packaging label) can differ from the product number (on the label directly on the spare part)!
• The order number of the relevant spare part set can be found by entering the product number of the spare part in the spare parts finder.
• We recommend that the Installation Instructions be kept with the packaging at all times.
Confirmation whether the spare part is permitted to be used with the measuring device
The spare parts set and Installation Instructions are used to replace a faulty unit with a functioning unit of the same type. Use genuine
parts from Endress+Hauser only. Only original spare parts supplied by Endress+Hauser shall be used with the measuring device.
Therefore, before use, check whether the spare part set is compatible with the measuring device.
A spare parts overview label is located in the connection compartment cover of the measuring device. If there is no label or the spare
part is not listed the appropriate spare part can also be identified via W@M Device Viewer.
How carrying out such a check via the W@M Device Viewer is described below:
Choose the Endress+Hauser Device Viewer via web browser: www.endress.com/deviceviewer
Enter the serial number (Ser. No.) of the device into the W@M Device Viewer (on the label of the transmitter), then click on "Spare parts".
The list of the available spare parts for the device is displayed.
Check the order number on the packaging label of the spare part set.
Check whether the order number of the spare part set is specified in the list displayed by the device viewer:
= YES, the spare part can be used.
= NO, the spare part may not be used.
If you have any questions, contact your Endress+Hauser service organization.
Products
Content of the spare part kit
1 × power supply, 1 × I/O-board, 1 × amplifier, 
1 × print carrier, terminal connections, 1 × ribbon cable, material for assembling
1 × power supply, 1 × terminal connection
1 × I/O-board, terminal connections
1 × amplifier, 1 × ribbon cable
2.
Ser . No.:12345
i
i
www.endress.com/deviceviewer
Solutions
1.
Device Viewer
Ser . No.:12345
4.
3.
=
?
5.
Services
A0016264