Werbung
Maintaining, Cleaning and Storing
Always keep the soldering tip coated with tin to ensure a long
service life.
Clean dirty soldering tips using a moistened cleaning sponge
while the soldering iron is hot.
If the soldering tip became hard to wet, use solder and flux to
reactivate it. Wrap some solder with included flux around the
cold tip and heat the tip until the solder melts.
Regularly clean oxidation off the soldering tip after dismounting
with fine emery paper (600 – 800 grain). This kind of residue
may also form in the heating element. Carefully blow it out.
After cleaning, the soldering tip must be coated with tin.
Always pull the power plug before cleaning and allow the unit
to cool down completely!
Only use a brush or a slightly moistened cloth to clean the unit.
Allow the unit to dry completely before next use. Do not use
abrasives or aggressive chemicals or similar cleaning agents.
Store the soldering iron indoors in a dry place that is protected
from dust, dirt and extreme temperatures.
Store the unit out of reach of children.
Operation
11
Werbung
