Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Switch off the device and remove
the battery before carrying out any
maintenance work.
1. Loosen the mounting screw (10)
of the sprocket cover (9)
(
2. To tension the saw chain, turn
the screw (8) for the chain quick-
tensioning system in the direction
.
To loosen the tension, turn the
screw (8) for the quick-tensioning
system in the direction
3. Tighten the mounting screw (10)
of the sprocket cover (9) again
(
The chain tension of a new saw
chain must be readjusted after a
maximum of 5 cuts.
Removing/inserting the
rechargeable battery
1. To insert the batteries (14) into the de-
vice, push the batteries along the guide
rails into the device. You will hear
them click into place.
2. To remove the batteries (14) from the
device, press the release button
(
14a) on the batteries and pull the
batteries out.
Operating
Switch on the chainsaw only when
chain bar, saw chain and sprocket
chain wheel covering are correctly
assembled.
Make sure you have a secure
stance. Before starting, ensure that
the electric chainsaw is in contact
with no objects.
).
).
Never operate the device without
the front cut protection. Risk of in-
jury!
Switching on
1. Place the battery (14) into the device
(see "Inserting/removing the recharge-
able battery").
2. Check the load status of the recharge-
able battery before starting.
3. Hold the device fi rmly with both hands,
with your right hand on the handle
.
(5) and left hand on the grip (2). Your
thumb and fi ngers must tightly clasp the
handle (5). Never use the device one-
handed. Risk of injury!
4. To turn on, press the switch lock (3)
with your thumb or index fi nger and
then press the on/off switch (4); the
device will run at maximum speed. Re-
lease the switch lock (3).
5. The device will switch off again when
you release the on/off switch (4). The
device cannot be switched to continu-
ous operation.
Battery charge level
indicator
The charge level of the batteries is indi-
cated by illumination of the corresponding
LED lights of the battery charge level indi-
cator during operation.
3 LEDs illuminated (red, orange and green):
Batteries charged
2 LEDs illuminated (red and orange):
Batteries partially charged
1 LED illuminated (red):
Batteries need to be charged
GB
IE
NI
15
Werbung
