Hitachi YUTAMPO Serie Installations- Und Betriebshandbuch Seite 22

UNIT CONTROLLER
9.6 MENU NAVIGATION
In order to access to the main menu, press " " the button.
Description
Operation Information –DHW
Operation
Current Temperature
Setting Temperature
El.Heater Status
El.Heater Op
Legionella Status
Legionella Op.
Operation Information - Heat Pump Details
Outdoor Ambient T
Discharge Gas T (R410A)
Evaporation Gas T (R410A)
Inverter Op. Freq. (R410A)
Defrosting
Compressor Curr. (R410A)
Unit capacity
Unit Type
Operation Information - Energy data
Operation Information - Energy data - Input Power
DHW
Total
Operation Information - Alarm History
System Configuration –General Options
System Configuration –General Options - Central Operation
Control Type
System Configuration – General Options - H-LINK Address
Refrigerant Cycle Address
Indoor Unit Address
System Configuration - Timer and Schedule
System Configuration - Timer and Schedule - DHW
Timer Type
Timer configuration
Frequency
Starting time
Setting Temperature
Stopping time
Reset configuration
16 PMML0451 rev.2 - 03/2018
Default
Range
value
Operation Information
- Demand ON/OFF
- -
- -
- Enabled/Disabled
- Demand ON/OFF
- Enabled/Disabled
- Demand ON/OFF
- -
- -
- -
- -
- -
- -
- -
Yutampo -
- -
- -
System Configuration
Local Local/Full
0 0 ~ 63
0 0 ~ 63
Disabled
Disabled Simple Timer
Schedule
- -
Never
Once
Everyday -
Weekend
Workday
06:00 00:00 to Stopping – 00:10
- -
12:00 Starting +00:10 to 24:00
- -
Steps Unit
- -
- ºC
- ºC
- -
- -
- -
- -
- ºC
- ºC
- ºC
- Hz
- -
- A
- HP
- -
- kWh
- kWh
In case that the Yutampo unit is connected a central
operation device (KNX,Modbus, etc.)
- -
Local: Central orders are disabled
Full: Central orders are enabled
1 - H-LINK communication addresses must be
assigned in case that the Yutampo unit is
connected to a central operation device (Default
1 -
values: 1:1)
- -
- -
- ○
ºC 00:10
ºC 1
- 00:10
- -
Description