Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Temperature level
14
15
Rapid Heating
Table 1: Operation time limits
Overheating protection
Your hob is equipped with some sensors
ensuring protection against overheating.
The following may be observed in case of
overheating:
• Active cooking zone may be turned off.
• Selected level may drop. However, this
condition cannot be seen on the indic-
ator.
Overflow safety system
Your hob is equipped with a safety system
to prevent overflows. If there is overflowing
that affects the control panel, the system
will turn off the hob by disconnecting the
power automatically. Meanwhile, "E" or "F"
will be displayed.
Precise power setting
Induction hob reacts the commands imme-
diately as a feature of its operating prin-
ciples. It changes the power settings very
fast. Thus, you can prevent a cooking pot
(containing water, milk and etc.) from over-
flowing even if it was just about to over-
flow.
Keep the surface of the touch con-
trol panel clean. It may give erro-
neous operation warning.
No pots/pans must be placed on
the touch control panel.
Operating Hood and Hob as connected
(Hob to Hood) (It varies depending on the
product model. It may not be available
on your product.)
If your product has "
product has the ability to operate in con-
junction with the hood. You can connect
your hob and hood via this feature allowing
your hood to operate automatically by ad-
justing the extraction level for optimum per-
" symbol, your
EN / 24
Operation time limit - hour
1
1
10 minutes
formance according to the set heating level
of your hob. In order to do this you must
first connect your hood and hob to each
other, once this is done you can activate
the connection on the hob allowing the hob
and hood to work together.
Matching the hob and hood to one another
The process of connecting hob and hood is
required only once. To connect the hob and
the hood, simply activate the connection
via the hob after the initial connection has
been achieved.
1. To turn on the hob, touch the "
2. Touch the "
" key for 3 seconds ap-
proximately.
ð "
" symbol flashes on the display.
3. Activate matching to the hob on your
hood (see the hood manual) and the
corresponding symbol on the hood will
start to flash.
ð When the matching is complete, the
"
" symbol on the hob and the corres-
ponding symbol on the hood con-
stantly appear.
Activating the connected operation of the
hob and the hood
1. To turn on the hob, touch the "
2. Touch the "
" on the hob.
3. When activation is complete, the corres-
ponding symbol in the hood and the "
symbol on the hob will appear continu-
ously.
ð Depending on the total temperature
level of your hob, your hood will auto-
matically run, increase or decrease the
level.
EN
DE
FR
" key.
" key.
"
Werbung
