Werbung
Verfügbare Sprachen
Verfügbare Sprachen
When charging the battery, make sure the ambient temperature is between 5 ° C and 35 ° C.
Note
Charging the battery in temperatures outside of this range might prevent the battery from being
fully charged. As a result, the battery might take a long time to charge, or you might only be able
to use the vacuum cleaner for a short time.
If the battery indicator does not turn on, or it turns on briefly and then turns off, remove the
vacuum cleaner from the charging station and then set it back onto the charging station.
If you are using the vacuum cleaner for the first time or after the vacuum cleaner was left unused
for a long time, the battery might take a long time to charge, or you might only be able to use the
vacuum cleaner for a short time.
Charging it near a radio might cause sound interference when the radio is in operation. When
charging the vacuum cleaner, plug the AC adapter into an outlet that is at least 2 meters away
from any radio equipment.
To prolong battery life
Be sure to charge the vacuum cleaner after each use, even if you only used the vacuum cleaner for a short
period of time.
If the vacuum cleaner is not to be used for more than a month, please fully charge the battery before storing
it. Charging it once a year if the vacuum cleaner is not in use will prolong the battery life. (Storing a depleted
battery will deteriorate the battery performance and battery life.)
If the vacuum cleaner stops in the middle of operation because the battery has run out, you might still be able
to use the vacuum cleaner for a short while by pressing the control buttons. However, this type of action is
not recommended.
Performing this type of action will shorten the battery life.
Disassembling the charging station
Unplug the AC adapter.
Disconnect the cord and connector, and then detach the wall bracket
and stand pipe.
1
2
3
Connector
Gently pull the cord in the
direction indicated by the
arrow.
Button
To disassemble the charging station, remove each segment, starting
from the top. At each of the locations to , hold onto the upper
segment, hold down the button, and slowly pull in the direction
indicated by the arrow.
Hold the connector, and
disconnect it by polling in
the direction of the arrow.
EN-19
Werbung
