Using The Bonnets; Operating - Westfalia 81 43 84 Originalanleitung

can be inserted without resist. Do not force it. During charging the
battery and the charger become warm.
After charging the charger automatically switches off and the indicator
lamp turns on green. Remove the battery and disconnect the power
supply unit from power mains.

Using the Bonnets

The terry-cloth bonnet (9) is for applying the polishing agent. Use the foam
pads (6, 7 and 8) to evenly distribute the polishing agent. Use the
polishing bonnets made of lambskin (10) or cotton (11) for buffing out the
surface.
1. To attach the terry-cloth bonnet place the machine with the pad holder
(5) on top.
2. Attach the foam pad (6, 7 or 8) with the suitable notch on the hook and
loop surface of the pad holder press the foam pad evenly on the pad
holder.
3. Now pull the bonnet over the pad holder. The bonnet must be wrinkle-
fee and fits correctly.
Operation
The dust developed when using some polishing agents may be a health
hazard. Because of this wear a dust mask and eye protection.
Before you start, make sure car and work area are clean and dry.
1. Attach one foam pad and the terry-cloth
polishing bonnet on the pad holder.
2. Apply polishing agent to the bonnet.
Spread it out evenly and observe the
instructions of the manufacturer of the
polishing agent. Do not apply too much
polishing agent.
3. Bring the machine down on the surface
and then switch it on. This way you will
avoid splashing.
4. Now move the machine evenly over the
surface. Do not apply downward pressure.
5. Before lifting the machine off the surface turn it off.
Operation
17