Klarstein 10028188 Anleitung Seite 14

Installation of the C shape buckle of the heat exhaust hose and unit
• Take out the C shape buckle of the heat exhaust hose and remove the plastic bag.
• Point the rotary hole at the end of the heat exhaust hose snap toward the rotation shaft of the back
shell and slide it onto the back shell in accordance with the snap joint direction of the rotation shaft
on the back shell (see picture). When the end snap joint at the end of the rotation shaft of the back
shell sticks out of the snap, it means that the heat exhaust hose snap has been slided into place.
• Rotate the C shape buckle counterclockwise to clip the snap joint of the C shape buckle of the back
shell successfully through the guide of the slide way of the back shell (see picture).
Installation of the heat exhaust hose assembly and unit
• Pull the end of the heat exhaust hose apart by several turns.
• Hold the end handle of the C shape buckle with the left hand and the heat exhaust hose short
connector with the right hand, put one end of the heat exhaust hose that is pulled apart onto the
snap of the lower air duct bottom, press the C shape buckle with the left hand by force so that the
C shape buckle of the heat exhaust hose clips the snap joint of the back shell. The end of the heat
exhaust hose must reach one step inside the bottom of the lower air duct (see picture).
• The few turns at the end of the heat exhaust hose must be snapped in the snap of the lower air
duct bottom. The C shape buckle that clips the heat exhaust hose must clip the back shell and heat
exhaust hose firmly. Hold the unit with one hand and the heat exhaust hose short connector with
another hand; or both people cooperate with one person holding the unit and the other person
pulling the heat exhaust hose to prolong the heat exhaust hose gently.
•
14