Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
EN
Routine Maintenance
Clean the Mopping Module
1. Press the two release clips on the side of water tank, remove the
mopping module and pull the mop pad off the mopping module.
2. Pour out the water in the tank. Clean with water only and leave
to air dry before re-installing.
Note: Do not expose the tank to the sun directly.
14
3. Clean the mop pad with water only and leave to air dry before
re-installing.
Note:
• Remove the pad from the mopping module before cleaning it, and make
sure dirty water does not flow back into the water outlet to avoid clogging.
• For optimal performance, it is recommended to replace the mop pad every
3 to 6 months.
4. If slow water flow occurs, or the volume is not well-distributed,
please clean the air hole in the cover of the water tank.
Routine Maintenance
Clean the Main Brush
Press the brush guard clips inwards to remove the brush guard
and lift the brush out of the robot.
Pull out the brush cover as shown in the diagram. Use the
included cleaning tool to remove any hairs tangled in the brush.
Clean the Main Wheel / Omnidirectional Wheel
Note: Use a tool such as a small screwdriver to separate the axle and the tire.
Clean the Side Brush
Pull out the side brush and use the included cleaning tool to
remove any hair tangled on the brush.
EN
15
Werbung
Inhaltsverzeichnis
