Herunterladen Inhalt Inhalt Diese Seite drucken

Side Broom Height Check And Adjustment - Nilfisk SR 1300H B Betriebsanleitung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

ENGLISH
SIDE BROOM HEIGHT CHECK AND
ADJUSTMENT
NOTE
Brooms with harder or softer bristles are available.
This procedure is applicable to all types of brooms.
1.
Check the side broom distance from the ground, according
to the following procedure:
Drive the machine on a level ground.
Keep the machine stationary, lower the side brooms
and turn them on for a few seconds.
Stop and lift the side brooms, then move the machine.
Check that the side broom prints are as shown in the
fi gure (A and B, Fig. 9).
2.
If the print is not within specifi cations, adjust the side
broom height according to the following procedure.
3.
Engage the parking brake with the pedal (76) and the lever
(69).
4.
Turn the ignition key (68) to "0".
5.
Open the hood (22) and secure it with the support rod (37).
6.
For the right side broom, operate on the idle gear of
the lever (A, Fig. 10), by loosening the ring nut (B) and by
adjusting the adjuster (C) until the correct print (A, Fig. 9)
is achieved. Then fasten the adjuster with the ring nut (B,
Fig. 10).
7.
For the left side broom, operate on the idle gear of the
lever (D, Fig. 10), by loosening the ring nut (E) and by
adjusting the adjuster (F) until the correct print (B, Fig. 9)
is achieved. Then fasten the adjuster with the ring nut (E,
Fig. 10).
8.
Perform step 1 again to check the proper adjustment of the
side broom height.
9.
When the broom is too worn to be adjusted, replace it as
shown in the next paragraph.
NOTE
If necessary, the side broom tilting can be adjusted
too (see the procedure in the Service Manual).
22
USER MANUAL
146 1062 000(3)2007-02 A
SR 1300H B
Figure 9
Figure 10
S311394
S311423

Werbung

Inhaltsverzeichnis

Fehlerbehebung

loading

Inhaltsverzeichnis