Bresser 7003100CM3000 Bedienungsanleitung Seite 33

UV INDEX
To show the current UV index that detected by the wireless 7-in-1 sensor.
LIGHT INTENSITY
To show the current light intensity that detected by the wireless 7-in-1 sensor.
To set the light intensity unit of measure: Klx (lx), Kfc (fc) and W/m².
1. When the reading is showing, press and hold [ INDEX ] key with 2 seconds to enter light intensity unit
setting mode.
2. Press [ UP ] or [ DOWN ] key to change the unit in sequence: Klx (lx)
3. Press [ INDEX ] key to exit the setting.
FEELS LIKE
Feels Like Temperature shows what the outdoor temperature will feel like. It's a collective mixture of Wind Chill
factor (18°C or below) and the Heat Index (26°C or above). For temperatures in the region between 18.1°C to
25.9°C where both wind and humidity are less significant in affecting the temperature, the device will show the
actual outdoor measured temperature as Feels Like Temperature.
HEAT INDEX
The heat index, which is determined by the wireless 7-IN-1 sensor's temperature & humidity data, when the
outdoor temperature is between 27°C (80°F) and 50°C (120°F).
Heat Index range
27°C to 32°C (80°F to 90°F)
33°C to 40°C (91°F to 105°F)
41°C to 54°C (106°F to 129°F)
≥55°C (≥130°F)
WIND CHILL
A combination of the wireless 7-IN-1 sensor's temperature and wind speed data determines the current wind
chill factor. Wind chill number are always lower than the air temperature for wind values where the formula
applied is valid (i.e. due to limitation of formula, actual air temperature higher than 10°C with wind speed below
9km/h may result in erroneous wind chill reading).
DEW POINT
- The dew point is the temperature below which the water vapor in air at constant barometric pressure
condenses into liquid water at the same rate at which it evaporates. The condensed water is called dew
when it forms on a solid surface.
- The dew point temperature is determined by the temperature & humidity data from wireless 7-IN-1 sensor.
UV INDEX AND LIGHT INTENSITY CALIBRATION
1. When the UV index reading is showing, press and hold [ INDEX ] key with 2 seconds to enter the UV
calibration mode.
2. Press [ UP ] or [ DOWN ] key to adjust the UV gain value. (Default is 1.0)
3. Press [ INDEX ] key again to enter the light intensity calibration mode.
4. Press [ UP ] or [ DOWN ] key to adjust the light intensity gain value. (Default is 1.0)
5. Press [ INDEX ] key to exit calibration.
HISTORY DATA (ALL RECORDS IN THE PAST 24 HOURS)
The console will record past 24 hours weather data automatically that included past indoor and outdoor
temperature & humidity, baro, wind chill, wind speed and rainfall records.
1. Press the [ HISTORY ] key to check past 1 hour history records.
2. Press [ HISTORY ] key repeatedly to show past 2, 3, 4 , 5.......24 history weather records.
Warning
Caution
Extreme Caution
Danger
Extreme Danger
33
Kfc (fc)
Explanation
Possibility of heat exhaustion
Possibility of heat dehydration
Heat exhaustion likely
Strong risk of dehydration / sun stroke
W/m 2 .