Hands Free Use (Vox) - Motorola T5022 Bedienungsanleitung

6864239V01_EN.fm Page 9 Monday, May 15, 2006 11:53 AM
2.To restore the channel to the scan list, turn the radio
off and then on.
3.You cannot remove your home channel from the
scan list (your home channel is the channel your
radio was set to when you activated scan).

Hands Free Use (VOX)

VOX allows you to talk "hands
free" when used withoptional
accessories connected to the
radio.
Note: When using audio
accessories with your
radio, turn the volume of
your radio down before
you place the accessory
on your head or in your
ear.
How To Use The VOX Feature
1.Switch off your radio.
2.Insert the plug of the audio accessory into the
accessory jack.
g
3.Switch on your radio. The flashing icon will
appear in the display to indicate that the VOX feature
is active.
4.To transmit, speak into the accessory microphone.
To receive, stop talking.
5.Pressing or removing audio accessory will
M
disable VOX operation.
Note: There is a short delay after you start talking,
before the radio transmits.
Setting the Sensitivity Level
Adjusting the VOX and/or microphone sensitivity level
helps to minimize the possibility of unintended noises
triggering a transmission, or enhances the ability to pick
up quiet voices.
If an accessory is fitted to your radio these instructions
will help you to adjust the VOX sensitivity. If no
accessory is fitted the microphone sensitivity will be
adjusted.
g
1.Press \ until and a flashing number appear in
the display.
2.Select sensitivity level of 1, 2 or 3 by using
[ .
1 - If you speak loudly, or are in a noisy environment.
2 - Suitable for most applications.
3 - If you speak softly, or are in a quiet environment.
Note: When you connect a VOX accessory, the radio
will automatically be set to the last chosen VOX
sensitivity level.
The T5022 also has a built in Internal Voice Operated
Transmission capability. This is a similar function to the
VOX because the sound of your voice activates
transmission, but no external accessories are needed.
Selecting the Internal VOX Feature
Either:
g
1.Press \ until the flashing icon appears in the
display and the channel number is replaced with
n
(enabled) or (disabled).
2.Use the up ] or down [ button to select
enable.
] or
Y
Y
for
9