Your New Radio; Batteries And Battery Charging - Motorola T5022 Bedienungsanleitung

6864239V01_EN.fm Page 5 Monday, May 15, 2006 11:53 AM

Your New Radio

The Motorola T5022 two-way radio operates on
PMR446 frequencies, and can be used in any country
where PMR446 frequencies are authorized, subject to
applicable regulations. This license-free, two-way radio
service is for family and group recreational use. Use of
this radio outside the country where it was intended to
be distributed is subject to government regulations and
may be prohibited. Read this manual carefully and
make sure you know how to operate the radio properly
before use.
Please retain your original dated sales receipt for your
records. For warranty service of your Motorola two-way
radio you will need to provide a copy of your dated
sales receipt to confirm warranty status.

Batteries and Battery Charging

The radio operates with 3 AA Alkaline batteries or a
Nickel-Metal Hydride (NiMH) rechargeable battery
pack (supplied with your radio).
Caution: Do not disassemble the NiMH battery
pack.
Note: Remove batteries before storing your radio for
extended periods. Batteries corrode over time
and may cause permanent damage to your
radio. Exercise caution when handling batteries
that are leaking. Dispose of exhausted batteries
at a designated battery disposal unit and not in
the household waste.
Installing the Batteries
1.Lift battery latch to release the battery cover.
2.Insert 3 AA batteries as shown by the markings
inside the battery compartment. Alternatively insert
the NiMH pack so that the charge contacts are facing
outwards to connect with contacts on the battery
cover.
3.Reposition battery cover and press down until it
clicks into place.
Charging Desk Stand
The charging desk stand provides drop-in charging
convenience. The charging desk stand can be placed
on any flat surface, such as a desk or workbench.
Charge the NiMH battery overnight (16 hours) before
using it for the first time.
1.With the radio OFF, remove the battery cover.
2.Insert the battery pack as indicated on the battery
pack label.
3.Replace the battery cover.
4. Plug the wire on the AC power supply into the plug
on the desk stand.
5.Plug the AC power supply into a standard wall
socket.
6.Slide the radio into one of the desk stand charging
pockets, facing forward. The red light will glow if the
radio is properly inserted.
5