Maintenance; Daily Service; After 200 Mountings; Removing Residues - struers ProntoPress-10 Gebrauchsanweisung

Daily Service

After 200 mountings

Removing residues

Resetting the counter

Cleaning the Rams

48
ProntoPress-10
Instruction Manual

7. Maintenance

Clean all accessible surfaces with a moist cloth.
When mounting, some old cured resin will fall down from the
lower ram and built up underneath. The cured resin must be
cleaned away, to avoid it harming the machine. The axle journal
securing the lower ram has been designed to break in this case,
thus preventing serious damage to the machine.
After 200 mountings a message will appear in the display,
reminding you to remove the resin residues.
Remove the mounting unit. See this section.
Remove the resin under the lower ram with a cloth or a soft
brush.
Install the mounting unit. See this section.
Remove the message and reset the counter by pressing F1
when the message appears.
Before each mounting, check that there is no resin left on the flat
surface of the rams from previous operations. Clean the cylindri-
cal surface of the upper ram and the intermediate ram (if fitted).
Cured resin can easily be removed without any damage to the
surface of the rams using the scraper supplied.
If the rams have been scratched on the polished surfaces,
disassemble and polish them with 6 or 3 µm diamonds on a
polishing cloth.
Do not polish the surface on the sides of the rams. If the sides of the rams
are heavily scratched, they must be scrapped. If the top closure has been
dropped, causing a dent or deformation in the edge of the upper ram, the
Important
ram must also be scrapped.