Napoleon TQ240 Bedienungsanleitung Seite 12

12
CAUTION!
!
exist, do not use the gas grill. Have the part replaced by your Napoleon Grill dealer or qualified gas
EN
installer.
Troubleshooting
Problem
Low heat / Low flame
when valve turned to
high.
Excessive flare-ups/
uneven heat.
Burners burn with
yellow flame, accom-
panied by the smell
of gas.
Flames lift away from
burner, accompanied
by the smell of gas,
and possibly difficul-
ties in lighting.
Burner will not light
with the igniter,
but will light with a
match.
Humming regulator.
"Paint" appears to be
peeling inside lid or
hood.
Burner output on
"high" setting is
too low. (Rumbling
noise and fluttering
blue flame at burner
surface.)
www.napoleon.com
Check for abrasions, melting, cuts, and cracks in the hose. If any of these conditions
Possible Causes
Blockage of gas.
Improper preheating.
Improper preheating.
Excessive grease and ash build
up in drip pan.
Possible spider web or other
debris, or improper air shutter
adjustment.
Improper air shutter adjust-
ment.
Jet-fire outlet is dirty or
clogged.
Normal occurrence on hot
days.
Grease build-up on inside
surfaces.
Lack of gas.
Supply hose is pinched.
Dirty or clogged orifice.
Spider webs or other matter in
venturi tube.
Solution
Check for spider webs in the burner or orifice.
Preheat grill with main burners on high for 5 to
10 minutes.
Preheat grill with both main burners on high
for 5 to 10 minutes.
Clean drip pan regularly. Do not line pan with
aluminum foil. Refer to cleaning instructions.
Thoroughly clean burner by removing. See
general maintenance instructions. Open air
shutter slightly according to combustion air
adjustment instructions. (This must be done
by a qualified gas installer.)
Close air shutter slightly according to combus-
tion air adjustment instructions. (This must be
done by a qualified gas installer.)
Clean jet-fire outlet with a soft bristle brush.
This is not a defect. It is caused by internal
vibrations in the regulator and does not affect
the performance or safety of the gas grill.
Humming regulators will not be replaced.
This is not a defect. The peeling is caused by
hardened grease, which dries into paint-like
shards that flake off. Regular cleaning will pre-
vent this. See cleaning instructions.
Check gas level in propane cylinder.
Reposition supply hose as necessary.
Clean burner orifice.
Clean out venturi tube.
N415-0699CE-W REV - DEC 06.22