Installing The Appliance - hanseatic HEKS8854GD Gebrauchsanleitung

Page EN-26 Installing the appliance and reversing the appliance door

Installing the appliance

Before installation, check that the door
hinges are on the correct side. Change
the position of the door hinges if necessary
(see "Changing the door hinges" on
page EN-28).
For installation, you will need a PH2 cross-tip
screwdriver.
1. Switch off the fuse for the intended sock-
et (220–240 V~ / 50 Hz). Then insert the
mains plug into the socket.
2. Slowly and carefully push the refrigerating
appliance into the built-in cabinet. Make
sure that the side to be opened is as close
as possible to the wall of the cabinet.
(16)
(11)
3. There are holes pre-drilled in the out-
side edges of the appliance door for the
slides (11) to be attached. Use the short
screws (16) to fasten the slides on the
side that is to be opened.
4. Push the runners (13) into the slides.
5. Close and open the cabinet door to check
that it closes fully and easily. If necessary,
correct the position of the refrigerating ap-
pliance.
6. Open the appliance door and cabinet door
at the same time. As you do so, mark the
best position for the runners on the inside
of the cabinet door.
7. Remove the runners from the slides
again.
8. Use 2 short screws (16) to fasten each of
the runners (13) to the inside of the cabi-
net door at the marked positions.
9. Press the covers (14) onto the run-
ners (13).
(13)
10. Unscrew the slides (11) again and push
them onto the fitted runners (13).
11. Screw the slides back onto the appliance
door (2).
(13)
(16)
(13)
(14)
(13)
(11)