hanseatic HEKS8854GD Gebrauchsanleitung Seite 42

Page EN-6 Safety
■ Inspections and repairs to the appli-
ance may only be carried out by au-
thorised specialists. Please contact
our service department if necessary
(see "Service" on page EN-33).
■ Only parts corresponding to the orig-
inal appliance specifi cations may be
used for repairs.
■ In the event of a fault, as well as be-
fore extensive cleaning, pull out the
mains plug or switch off/unscrew the
fuse.
■ Do not put any objects in or through
the housing openings, and also en-
sure that children cannot insert any
objects into them.
■ Do not remove the covers from the in-
terior light. Do not attempt to replace
the interior light. Please contact our
service department if necessary (see
"Service" on page EN-33).
■ Check the appliance regularly for
damage.
Fire hazard!
Improper handling of the appliance can
lead to fi re and damage to property.
■ Do not connect to a timer or a sepa-
rate remote-controlled system for dis-
tance monitoring and control.
■ Do not locate multiple portable sock-
et-outlets or portable power supplies
at the rear of the appliance.
Risks associated with using
refrigerants
WARNING
Risk of fi re and explosion!
Your appliance's refrigeration circuit
contains the environmentally friendly,
but fl ammable and – as a mixture of air
and gas – explosive refrigerant R600a
(isobutane).
■ Do not use mechanical devices or oth-
er means to accelerate the defrost-
ing process, other than those recom-
mended by the manufacturer.
■ Mechanical intervention in the refrig-
eration system must only be carried
out by authorised specialists.
■ Do not damage the refrigerant cir-
cuit, e.g. by puncturing the refrigerant
channels of the condensate evapora-
tor with sharp objects, bending the
piping, or cutting open the insulation.
■ Ensure that none of the cooling fi ns
or tubes on a cooling appliance are
damaged prior to the point of proper
disposal.
■ To prevent the formation of a fl am-
mable gas-air mixture in the event
of a leakage in the refrigeration cir-
cuit, the installation space must have
a minimum size of 1 m
refrigerant in compliance with the
EN 378 standard. The amount of re-
frigerant contained in your appliance
can be found on the type plate.
■ To avoid the formation of sparks, do
not pull out the mains plug in the
event of a gas leak.
3
per 8 g of