Inhaltsverzeichnis
Werbung
The wine cellar must be positioned such that the plug is accessible. Release the power cord.
Move your wine cellar to its final location.
Leveling your wine cellar: Wine cellar must be leveled BEFORE loading your wines.
Your wine cellar is equipped with 4 adjustable feet to facilitate easy leveling.
that you tighten the back feet to the maximum and adjust the front feet to level the wine cellar.
INSTALLATION INSTRUCTIONS FOR BUILT IN WINE CELLARS: N A CABINET OR IN A
COLUMN
) F
RONT VENTING WINE CELLARS ONLY
SOMMELIER 40,40/1,601-2-3 models are free standing only. Any built in voids the warranty.
1. "Built in" wine cellars are front venting but are not designed to be fully integrated behind a
joinery door.
2. Please follow the installation diagram when installing built-in wine cellars. No less than the
minimum installation dimension, or it will affect the venting of cellar.
3. Built-in wine cellars draw air from right of ventilation frame(from the rear) and expel through
left of ventilation frame under the front door.
4. "Built in" wine cellars have a power switch located on the control panel so power point
location is not critical.
5. The wine cellar requires a standard 240 volt/10 amp power point.
6. The power cord is 2.0m in length and is fixed on the right side at the back when looking from
front of cabinet.
7. As with most appliances of today, the wine cellar has sensitive electronic components which
are susceptible to damage through lightning and electricity supply faults. It is therefore advised
to use a power surge protector to avoid problems of this nature.
8. Air vent on door must be provided for built-in wine cellars when a wood door is installed.
In Hot climate zone, an air vent or grid, with a minimum ventilation size of 200mm x 40mm
MUST be cut out at the rear top of the back partitioning or at the top of either side of the
partitioning, allowing cool fresh air full access to flow into the 30mm gap located at the rear of
the cabinet.
This air vent or grid must not be opened on the same side as other appliances such as ovens
or an area that is sealed and without access to fresh cool air. Failing to comply with the above
specifications could result in WARRANTY void.
INSTALLATION DRAWINGS FOR BUILT IN WINE CELLARS: N A CABINET OR IN A
COLUMN
) F
RONT VENTING WINE CELLARS ONLY
Note: The appliance must be positioned so that the plug is accessible after installed.
DIMENSIONAL DRAWINGS:
SOMMELIER 24 model
It is built-in model inside cabinet, the cabinet should
come with good ventilation space and no backplane,
otherwise it will affect the wine cooler working normally.
(Installation drawing as below)
(I
.
(I
.
We
recommend
22
Werbung
Inhaltsverzeichnis
