Corghi ET 1450 Betriebsanleitung Seite 95

Vehicle Balancing
type programme
dyn
ALU
1P
ALU
2P
ALU 3
ALU 4
ALU 5
STA
ALU 1
ALU 2
*The machine allows the operator to change the application position of the adhesive weight
from 12 o'clock or in the 6 o'clock position (using the laser pointer, if machine is equipped
with this accessory) to 6 o'clock (via the laser line), depending on his requirements.
To change the application position for the adhesive weights, follow the instructions in
the set up menu "Adhesive weight application position".
Operator's Manual ET 1450
Inner weight applica-
tion type and mode
clip weight to apply
manually at the 12
o'clock position
Adhesive weight to ap-
ply manually at the
12* o'clock position or
using weight holder if
present
clip weight to apply
manually at the 12
o'clock position.
adhesive weight to ap-
ply manually at the 12*
o'clock position.
clip weight to apply
manually at the 12
o'clock position
adhesive weight to ap-
ply manually at the 12*
o'clock position.
spring weight or adhesive weight to be applied
manually at the 12 o'clock position either on the
outer or inner side or at the centre of the rim well
clip weight
Adhesive weight to ap-
ply manually at the
12* o'clock position
clip weight to apply
manually at the 12
o'clock position
External weight appli-
cation type and mode
clip weight to apply
manually at the 12
o'clock position
adhesive weight to ap-
ply manually at the
12* o'clock position or
using weight holder if
present
adhesive weight to ap-
ply manually at the
12* o'clock position or
using weight holder if
present.
adhesive weight to ap-
ply manually at the
12* o'clock position
adhesive weight to ap-
ply manually at the 12*
o'clock position.
clip weight to apply
manually at the 12
o'clock position
Adhesive weight to ap-
ply manually at the
12* o'clock position
Adhesive weight to ap-
ply manually at the 12*
o'clock position.
UK
95