Pour In Chain Oil; Filling With Chain Oil; Filling With Fuel - Parkside PBKS 53 B3 Originalbetriebsanleitung

GB

Pour in chain oil

Only fill with chain oil when
the engine is switched off and
has cooled down. Overflow-
ing oil can cause a fire.
The blade bar and saw chain must
never be operated without oil. If the
petrol chainsaw is used with too little oil,
the cutting performance and lifespan of the
saw chain will decrease as the saw chain
will become blunt more quickly. You can
identify when there is too little oil if smoke
develops or the blade bar changes colour.
The oil flows to the blade bar (
soon as the engine starts running.

Filling with chain oil:

• Check the oil level regularly and top up
with oil if the level is low.
The tank volume can be found in the
chapter "Technical data".
• Use bio-oil containing additives to redu-
ce friction and wear. You can order this
from our online shop.
• If bio-oil is not available, use chain
lubricating oil with a low proportion of
adhesion additives.
Use only the recommended lubricant.
• Empty the oil tank if it will not be used
for a prolonged period of time
(6-8 weeks).
Illustration
1. Place the device on its side with the oil
tank cover (8) facing upwards.
2. Unscrew the oil tank cap (8) and pour
the chain oil into the tank.
3. Wipe away any spilt oil and close the
oil tank cap (8).
42

Filling with fuel

and keep any heat sources at a dis-
tance. Fuel and fuel vapours are
very inflammable. Do not add fuel,
oil or lubricating oil when the engi-
ne is running.
Carefully open the tank cover so that
any overpressure can slowly dissi-
pate.
Start the chainsaw at a distance of
at least 3 m from the fuelling point.
There is a risk of fire or explosion if
10) as this advice is not heeded.
mixtures that are older than 3 months. If
this not done, the engine may become da-
maged and your warranty will become null
and void.
fumes. There is a danger to health!
rated exclusively with a mixture of petrol
and two-stroke engine oil at a ratio of
40:1.
Fuel mixture table:
Petrol
1,00 liter
3,00 liter
5,00 liter
Mixing
process
Make sure there is good ven-
tilation when filling with fuel.
Do not smoke while refuelling
Use only the fuel mixture recommen-
ded in the instructions. The fuel mix-
ture ages. Therefore, do not use fuel
Avoid direct skin contact with
petrol and inhalation of petrol
The device is equipped with a two-
stroke engine and is therefore ope-
2-stroke oil
40 parts petrol + 1 part oil
25 ml
75 ml
125 ml