Introduction; Device Description - Scheppach 5901223901 Originalbetriebsanleitung

1.

Introduction

Manufacturer:
Scheppach GmbH
Günzburger Straße 69
D-89335 Ichenhausen
Dear Customer,
We hope your new tool brings you much enjoyment and
success.
Note:
In accordance with the applicable product liability laws,
the manufacturer of this device assumes no liability for
damage to the device or caused by the device arising
from:
• Improper handling
• Failure to comply with the operating instructions.
• Repairs carried out by third parties, unauthorised
specialists.
• Installing and replacing non-original spare parts,
• Improper use
• Failures of the electrical system in the event of the
electrical regulations and VDE provisions 0100, DIN
57113 / VDE0113 not being observed.
Note:
Read the whole text of the operating manual before as­
sembly and commissioning.
This operating manual should help you to familiarise
yourself with your device and to use it for its intended
purpose.
The operating manual includes important instructions
for safe, proper and economic operation of the device,
for avoiding danger, for minimising repair costs and
downtimes, and for increasing the reliability and ex­
tending the service life of the device.
In addition to the safety instructions in this operating
manual, you must also observe the regulations appli­
cable to the operation of the device in your country.
Keep the operating manual at the device, in a plastic
sleeve, protected from dirt and moisture. They must be
read and carefully observed by all operating personnel
before starting the work.
The device may only be used by personnel who have
been trained to use it and who have been instructed
with respect to the associated hazards. The required
minimum age must be observed.
26 | GB
In addition to the safety instructions in this operating
manual and the separate regulations of your country,
the generally recognised technical rules relating to the
operation of such machines must also be observed.
We accept no liability for accidents or damage that
occur due to a failure to observe this manual and the
safety instructions.
2. Device description (fig. 1-21)
1. Handle
2. On/off switch
3. Locking switch
4. Machine head
5. Moving saw blade guard
5a. Fixing screw
6. Saw blade
7. Clamping device
7a. Star grip screw
8. Workpiece support
9. Locking lever for workpiece support
10. Table inlay
11. Handle / set screw for rotary table
12. Pointer
13. Scale
14. Rotary table
15. Fixed saw table
16. Stop rail
16a. Moveable stop rail
16b. Locking screw
17. Dust bag
18. Angle scale
19. Angle pointer
20. Set screw for cable routing
21. Cable routing
22. Locking screw
23. Locking pin
24. Screw for cutting depth limiting
24a. Knurled nut for cutting depth limiting
25. Stop for cutting depth limiting
26. Adjusting screw (90°)
27. Adjusting screw (45°)
27a. Counternut (45°)
28. Flange screw
29. Outer flange
30. Sawing shaft lock
31. Inner flange
32. Laser
32a. Philips screw
33. Laser ON/OFF switch
34. Guide bar
www.scheppach.com