en
Tips on energy saving
Calc'nClean
Takes about 26 minutes�
Calc'nClean combines the functions
Descale and Clean� If both programmes
are due to be carried out close together, the
fully automatic coffee machine will automat-
ically suggest this service programme�
■ Touch E�
■ Touch [ Calc'nClean ] to select the
programme�
■ The display indicates the progress
of the programme�
■ Clean the beverage outlet and replace,
empty the drip trays and replace�
■ Open the ground coffee drawer, drop in
a cleaning tablet and close the coffee
drawer again�
■ Remove the water filter (if there is one)
and press C
■ Pour lukewarm water into the empty
water tank up to the "0�5 l" mark and
then dissolve one Bosch descaling tablet
TCZ8002 in it�
F
If there is not enough descaling
solution in the water tank, you will be
asked to do the following. Refill using
uncarbonated water and press C
again�
■ Remove the suction pipe from milk
container, wipe it and insert the end of the
suction pipe into the hole on the coffee
grounds container�
■ Close the appliance door�
■ Place a container with a capacity of
0�5 litre under the beverage outlet�
■ Press C� The programme will now run
for about 19 minutes�
■ Remove the container and press C�
■ Rinse the water tank and (if removed)
replace the water filter.
■ Fill the tank with fresh water up to the
"max" indicator�
■ Replace the water tank and close the
door�
■ Place the container underneath the
beverage outlet again�
56
THE EASIEST WAY TO SELF-IMPORT APPLIANCES DIRECT FROM EUROPE.
■ Press C� The programme will now
run for about 7 minutes and rinse the
appliance�
■ Remove the container, empty the drip
trays, replace and close the appliance door�
■ Press C� The appliance is descaled,
cleaned and ready for use again�
■ Touch E to exit the program�
Special rinsing
F
Important: If any of the service
programmes is ever interrupted, for
instance by a power failure, please
proceed according to the information
on the display:
■ Rinse the water tank and refill it with fresh
water up to the "max" mark�
■ Press C� The programme will now
run for about 2 minutes and rinse the
appliance�
■ Empty the drip trays, replace and close
the appliance door� The appliance is
ready for use again�
■ Touch E to exit the program�
Tips on energy saving
■ Press I to switch the appliance to
"energy saving mode"� The appliances
uses very little power when in "energy
saving mode", but monitors all safety-rel-
evant functions so as to avoid damage�
■ In the menu under "Switch off after",
set the automatic switch off period to
15 minutes�
■ Reduce the brightness of the display
and the illumination in the menu to save
energy�
■ If possible, do not interrupt the dispensing
of coffee or milk froth. Stopping a process
prematurely results in higher energy
consumption and the drip tray fills up
more quickly�
■ Descale the appliance regularly to avoid a
build-up of limescale� Limescale residues
cause higher energy consumption�