Zodiac Z350iQ Montage- Und Gebrauchsanleitung Seite 13

To access the electrical connection terminals and connect the unit to the power supply :
Unscrew the 7 screws.
Inside the appliance, pass the power cable through the bottom pre-created cable gland.
To wire on the spring-cage terminal block:
Pull the lever up as far as it will go, then connect the stripped (1cm) cable .
Return the lever back to its initial position
Spring-cage
terminal block
Remove the lateral panel.
x 7 screws
Pass the power cable through
bottom cable gland.
EN
11