Permitted Use; Residual Risks - Checchi & Magli WOLF PRO Bedienungs- Und Wartungsanleitung

Information and safety signs
The illustration shows where the safety
and information signs are positioned.
A) Hazard plate: signals the risk of
hands being crushed when adjusting
the tank to prevent it colliding with
the rear window of the cab.
B) Hazard plate: signals the risk of blows
when adjusting the tank to prevent it
colliding with the rear window of the
cab.
C) Information plate: states the electri-
cal connection voltage.

Permitted use

The device is designed and built to be used to water
seedlings during planting.
Watering can be done using water or a solution of water
and liquid fertilisers.
Use organic liquid fertilisers composed of substances
which are not classified and not classifiable as hazard-
ous.
Comply with limitations either set by or agreed on the
basis of current legislation concerning water and nature
Improper and unauthorised uses
The device must not be used in the presence of a poten-
tially flammable and explosive atmosphere.
The device must not be used with flammable or explo-
sive liquids.
The device must not be used if installed on unsuitable
work vehicles and incompatible tractors.
Liquids or liquid solutions must not be used at temper-

Residual risks

During the design and construction stages, the manufac-
turer has focused particular attention on safety aspects;
nevertheless the risks described below remain.
Crushing hazard: when handling the accessory, incor-
rect manoeuvres and mishandling of the load may cause
English language
TECHNICAL INFORMATION
A
B
UN41-0927UA
conservation.
Use the accessory only if installed on work vehicles pro-
duced by the manufacturer and authorisation has been
given.
The device must be used in a way that complies with
its technical characteristics, without modifications, and
must not be misused.
Any other use is considered improper and therefore it is
not authorised.
atures above the permitted level (see "Specifications").
The device must not be used if disassembled from the
work vehicle.
Solutions made with solid fertilisers must not be used
to prevent damage to the device.
The device must not be used with solutions made with
corrosive chemicals.
injury to the persons involved in the procedure.
Risk of pressurised liquid spurts: rupture of a tube or a
leakage of pressurised liquid can lead to the risk of skin
wounds and infections.
4
2
A
B
C
Use and maintenance