Electrolux TWL3E500 Benutzerinformation Seite 22

22 www.electrolux.com
WARNING!
Deactivate the appliance before carrying out any check.
In case of major problems, the acoustic signals operate, the display shows an
error code and the Start/Pause button may flash continuously:
Error code
E50
E90 or E91
EH0
If the display shows other error codes, deactivate and activate the appliance. If the
problem continues, contact the Authorised Service Centre.
In case of different problem with the tumble dryer check the table below for possible
solutions.
11.2 Troubleshooting
Problem
The tumble dry‐
er does not op‐
erate.
Possible cause
Appliance motor overloaded.
Too much laundry or entrap in
the drum.
Internal fail. No communication
between electronic elements of
the appliance.
The mains supply is unstable.
Possible cause
The tumble dryer is not connec‐
ted to the mains supply.
The door is open.
The On/Off (Ein/Aus) button was
not pushed.
The Start/Pause button was not
touched.
The appliance is in standby
mode.
Remedy
The programme was not comple‐
ted. Remove the laundry from
the drum, set the programme
and restart the cycle.
The programme was not finished
properly or the appliance stoped
too early. Switch the appliance
off and on again.
If the error code appears again,
contact the Authorised Service
Centre.
When the appliance is showing
EH0, please wait until main sup‐
ply is stable than press start. If
the appliance pause the cycle
without any indication then press
the cycle start. If the warning will
occur check the power cord /
socket integrity or main supply.
Remedy
Connect it to the mains socket.
Check the fuse in the fuse box
(domestic installation).
Close the door.
Push the On/Off (Ein/Aus) but‐
ton.
Touch the Start/Pause button.
Push the On/Off (Ein/Aus) but‐
ton.