Changing Over Door Hinges; Installation Dimensions; Installing In A Kitchen Unit; Fastening In The Recess - Electrolux IK 225 10 RE Gebrauchsanweisung

Changing over door hinges

1. Lift off covers .
3
2. Loosen attachment screws
3. Remove the door.
4. Replace all attachment screws
in a little way.
5. Unscrew door attachment screws
the diagonally opposite corner.
6. Suspend the appliance door on the
screws inserted previously and tighten
1
the screws.
7. Cover all open attachment holes with
covers .
3

Installation dimensions

Max. weight of unit door = 17,5 kg
24
on the appliance.
1
on the other side and screw
1
and transfer the hinges to
2
(mm)
Changing the compartment door
• At hinge fold away the cover.
1
• Unscrew hinge and remove the compartment door with the
1
hinge.
• Unscrew the closure .
2
• Close the holes with the plugs
• Rotate the door and closure by 180° and replace on the other
side: Insert the compartment door at the top, put the hinge
place at the bottom, screw down again and close the cover.

Installing in a kitchen unit

• Slide the attachment element
into the rail underneath the
appliance on the handle side
on the left or right, depending
on which side the handle is.
Screw into place with screw
3.5 x 11.
• Slide the appliance into the
recess.

Fastening in the recess

Fasten the appliance in the recess
- with the attachment profile at the
top A1,
- with the hinges at the side A2,
- with the attachment element at the
bottom A3.
.
3
in
1