Temperature / Humidity Function - Bresser WSX3001000000 Bedienungsanleitung

When clock reach the alarm time, alarm sound will start
Where it can be stopped by following operation:
- Auto-stop after 2 minutes alarming if without any operation and the alarm will activate again in
the next day
- By pressing [ALARM / SNOOZE] key to enter snooze that the alarm will sound again after 5
minutes
- By pressing and hold [ALARM / SNOOZE] key for 2 seconds to stop the alarm and will
activate again in the next day
- By pressing [ ALARM ] key to stop the alarm and the alarm will activate again in the next day
NOTE:
- The snooze could be used continuously in 24 hours
- During the snooze, the alarm icon "

TEMPERATURE / HUMIDITY FUNCTION

- The temperature and humidity reading are display on the outdoor and indoor (CH) section
- Use the [ °C / °F ] slide switch to select the temperature display unit
- If temperature / humidity is below the measurement range, the reading will show "Lo" If
temperature / humidity is above the measurement range, the reading will show "HI"
COMFORT INDICATION
The comfort indication is a pictorial indication
based on indoor air temperature and humidity in
an attempt to determine comfort level
NOTE:
- Comfort indication can vary under the same temperature, depending on the humidity
- There is no comfort indication when temperature is below 0°C (32°F) or over 60°C (140°F)
WIRELESS SENSOR SIGNAL RECEIVING
1 The console display signal strength for the wireless sensor(s), as per table below:
Outdoor 7-in-1 sensor
Indoor channel sensor
2 If the signal has discontinued and does not recover within 15 minutes, the signal icon will
disappear The temperature and humidity will display "Er" for the corresponding channel
3 If the signal does not recover within 48 hours, the "Er" display will become permanent You
need to replace the batteries and then press [ SENSOR / WI-FI] key to pair up the sensor
again
VIEW THE OTHER INDOOR CHANNELS (OPTIONAL FEATURE WITH ADD ON EXTRA
SENSORS)
This console is capable to pair with a wireless 7-IN-1 sensor and up to 7 wireless indoor
sensors If you have 2 or more Indoor sensors, you can press [ CHANNEL ] key to switch
between different wireless channels in normal mode, or press and hold [ CHANNEL ] key for 2
seconds to toggle auto-cycle mode to display the connected channels at 4 seconds interval
During auto-cycle mode, the
display Press [ CHANNEL ] key to stop auto cycle and display the current channel
" will keep flashing.
No signal
icon will show on the indoor channel section of the console's
19
Too cold Comfortable
Weak signal
Too hot
Good signal