Din En Iso 12100:2011; Nico Kowalski, Walther Spritz- Und Lackiersysteme Gmbh, Kärntner Str - WALTHER PILOT PILOT WA 51 Betriebsanleitung

Contents
Exploded Drawing
Dimension Sheet
Declaration of CE-Conformity
List of Replacement Parts
1 General
1.1 Identification of Model Versions
1.2 Normal Use
1.3 Improper Use
2 Technical Description
3 Safety instructions
3.1 Identification of safety instructions
3.2 General Safety Instructions
4 Assembly
4.1 Mounting of the Spray Gun
4.2 Connection of Input Lines
5 Operational Handling
5.1 Safety Warnings
5.2 Starting / Stopping Requirements
5.3 Spray Pattern Test
5.4 Spray Pattern Adjustments
5.5 Retooling of Spray Gun
6 Cleaning and Maintenance
7 Repairs
7.1 Changing the Needle Seal
7.2 Replacement of Nozzles, Needles, Springs and Seals
8 Troubleshooting and Corrective Action
9 Disposal of Cleaning and Servicing
Substances
10 Technical Data
2
4
23
24
26
26
26
27
27
27
27
28
28
29
29
29
29
30
30
30
31
32
33
33
33
34
34
35
22
Declaration of EC/EU-Conformity
We, the manufacturers of the equipment, hereby declare under our sole responsibility
that the product(s) described below conform to the essential safety requirements. This
declaration will be rendered invalid if any changes are made to the equipment without
prior consultation with us.
Manufacturer WALTHER Spritz- und Lackiersysteme GmbH
Kärntner Str. 18 - 30
D - 42327 Wuppertal
Tel.: +49(0)202 / 787 - 0
Fax: +49(0)202 / 787 - 2217
www.walther-pilot.de • e-mail: info@walther-pilot.de
Type Designation Automatic spray gun PILOT WA 51
round jet
wide/flat jet
Intended purpose Processing of sprayable media
Applied Standards and Directives
EU-Mechanical Engineering Directives 2006/42/EC
2014/34/EU (ATEX Directives)

DIN EN ISO 12100:2011-3

DIN EN 1953:2013
Specification according 2014/34/EU
Category 2 Part marking
Authorized with the compilation of the technical file:

Nico Kowalski, WALTHER Spritz- und Lackiersysteme GmbH, Kärntner Str. 18 - 30

D- 42327 Wuppertal
Special remarks :
The named product is intended for installation in other equipment. Commissioning is
prohibited until such time as the end product has been proved to conform to the
provision of the Directives 2006/42/EC.
Wuppertal, 31 January 2020
p.p.
Name: Torsten Bröker
Position: Manager, Design and Development
This Declaration does not give assurance of properties in the sense of product liability. The safety instructions
provided in the product documentation must be observed at all times.
V20306xxxx3
V20306xxxx3
DIN EN 1127-1:2019
DIN EN ISO 80079-36:2016
Tech.File,Ref.:
II 2G Ex h IIC T5 Gb
2406
23