Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
8.5
Port Forwarding
To set up port forwarding, proceed as follows:
1.
Open your web browser on your mobile device, and enter the IP address of your router in the
address bar.
Your router configuration page appears.
2.
Go to the port forwarding (or virtual server) rule configuration page.
Note: the naming of port forwarding or virtual server may vary based on the brand of your router.
Refer to the user manual of your specific router for more information.
The example below shows the screen for a D-Link router: select the "Advanced" tab and then
choose "Port Forwarding".
3.
Enter the camera IP address and port number that you noted down in step 7 of "Configuring the
Network", and enable this rule.
8.6
Checking the Connection
When you have completed network setup and port forwarding, check your connection setup as follows:
1.
On your mobile device, switch your network mode to 3G or connect to a different wireless network
than the one that has your camera connected.
2.
Start EagleEyes and select the camera you just added to see if you can access it.
If yes, your network connection is OK.
o
If no, the port number that you are using for the camera may be blocked. Return to step 7 in
o
"Configuring the Network" to change the port number.
8.7
Setting a Camera to Record to an SD Card
Basic Recording Settings in EagleEyes App
In EagleEyes, you can set a camera to record to its SD card as follows:
1.
Select the camera and
click the settings button
.
V. 01 – 06/05/2015
CAMIP23
2.
Under Record
Configuration, enable the
function by clicking [Yes].
8
3.
Set the resolution to
SXGA /HD720P.
©Velleman nv
Werbung
Inhaltsverzeichnis
