HSM SECURIO P44i Betriebsanleitung Seite 16

english
• Before starting up the machine for the fi rst
time, open the door and remove the three
wing nuts of the transport locks from the base
plate under the cutting unit.
6 Operation
Switching on the shredder
• Set mains switch at rear of paper shredder to „I".
• The fi rst time you switch on, select the language for the display messages.
 The set operating mode is displayed.
Swipe to change the operating mode.
Note
The temperature of the shredder motor is monitored. Should it overheat, not all operating modes
can be selected. You are informed of the situation by a message on the display. Once the motor has
cooled down suffi ciently, all modes are available again.
The shredder has 3 operating modes which vary with regard to shredding speed, throughput and
noise emission level:
Silent:
Standard:
Performance:
 The machine is ready to operate.
Note
Paper and CD cutting unit cannot be used at the same time. Only shred one kind of material at a
time.
16
for especially quiet operation
for optimum throughput capacity with low noise levels
for maximum shredding and throughput capacity
• In the case of particle cut machines, fi ll the oil
reservoir with cutting head oil (see Section 7
"Filling the oil reservoir").
• Connect the power plug of the machine into a
properly installed socket.
HSM SECURIO P44i
07/2022