Inhaltsverzeichnis
Werbung
DTF 35 SH • Operating Manual
GENERAL DESCRIPTION AND PRINCIPLE OF FUNCTION
Installation of the machine
1. Driving motor
• Electric motor (15 kW, 22 kW, 25 kW)
• LPG motor (ignition start)
2. Spray tod (water cooling)
3. Dust suction end connector
4. Emergency stop switch
5. Steering device: foot pedal down: easily
maneouvring (rear wheel lifted. Pedal up:
working position (engine off) --> braking
effect parking position)
6. Operation handle (for hydraulic advance)
stopps if letting go off.
7. Handwheel (Depth adjustment with scale)
8. Steering handle
9. Fatigue protection (Secure to the machine
operator's wrist. Automatically interrupts
the machine energy supply if the machine
operator is no longer able to control the
machine.
10. Drive wheels (Are connected directly to
hydraulic advance)
11. Belt guard (Safety device)
12. Propulsion lever (Directional and speed
indication)
13. Transport hooks (Fixing points for crane)
14. Tool shaft
15. Motor switch:
• 400 V / 50 Hz motor: off / on
• 480 V / 60 Hz motor: off / on
Mode of operation
Mode of operation
The surface treating machine works with a rotating tool drum or shaft. The tool drum or shaft
can be tipped with different diamond blades for hard, brittle hard and solid or viscoplactic
floors. The machined surface is cut with the diamond blades rotating.
Steering
Machines with a hydraulic advance are provided with a steering device to ensure the manoeu-
vrability at idle motor. Through pressing down the foot pedal the rear wheels are lifted from the
ground and the machine can be manoeuvred easily onto the guide rollers.
The pedal to be operated only with a lifted shaft or drum position
22
General description and principle of function
6
4
15
13
3
1
14
7
9
8
12
2
5
10
11
Werbung
Inhaltsverzeichnis
