18.1 Safety notices
Attention
► Only qualified electricians, who have been trained by the manufacturer, may carry out
any repairs on electrical equipment.
► Improperly performed repairs can cause considerable dangers for the user and
damages to the device.
18.2 Fault indications and rectification of faults
The following table assists in localizing and rectifying minor faults.
Fault
Humidor Volado
operate.
Humidor Volado is not cold
enough.
The light does not work.
Vibrations.
The Humidor Volado seems
to make to much noise
The door will not close
properly.
LED could not display.
LED display error - Lo
Bottoms are not functional.
Compressor will not start
caso Humidor Volado
do not
Not plugged in using different voltage. The circuit breaker
tripped or a blown fuse.
Check the temperature control setting.
External environment may require a higher setting.
The door is open too often.
The door is not closed completely.
The door seal does not seal properly.
The Humidor Volado
clearance.
Check the service center.
Check to assure that the Humidor Volado is level.
The Humidor Volado is not level.
Check the fan.
The Humidor Volado is not level.
The door is reversed and not properly installed.
The seal is weak. The shaves out of position.
Main control board does not work.
PCB Problem. There is some problem with the plug.
Weak quality of display.
Temperature point is out off. Check the service center.
Temperature controller panel is damaged.
Room temperature is lower than desired temperature.
Possible Cause
does not have the correct
36