Getting Started - Remington HC725 Anleitung

GETTING STARTED

Before using your hair clipper for the first time, charge for 14-16 hours
and then charge for 1 hour after the first usage.
Your clipper cannot be overcharged. However, if the product is not going to be used for an
extended period time (2-3 months), unplug it from the mains and store.
Fully recharge your hairclipper when you would like to use it again.
To preserve the life of your batteries, let them run out every six months then recharge for
14-16 hours.
HOW TO USE
Before starting the cut
To attach a comb
To remove the comb
2
080881_REM_IFU_HC725_22L.indd GB2 080881_REM_IFU_HC725_22L.indd GB2
ENGLISH
CHARGING YOUR HAIRCLIPPER
Ensure the product is switched off.
Connect the charging adaptor to the product and then to the mains.
A plug icon will be displayed on the product during charging.
CORDED USE
Connect the charging adaptor to the product and then to the mains.
When the cord is connected to the mains a plug icon is displayed on the hair clipper.
CAUTION: Extended mains only use will result in the reduction of the battery life.
CORDLESS USE
When the unit is switched on and fully charged, the LED fuel gauge will display
the maximum usage time of 45 minutes which will decrease during usage.
If the Fuel Gauge counter displays between 0 – 5 minutes, the display will flash to
indicate that the unit need to be recharged.
Inspect the clipper making sure that it is free from hair and dirt.
Seat the person so that their head is approximately at your eye level.
Before cutting, always comb the hair so it is tangle free and dry.
Hold the comb with its teeth upward
Slide it onto and along the clipper blade until the front of the comb firmly sits against the
clipper blade.
Holding the clipper with the blades facing away from you, firmly push the comb upward
and away from the blades.
14.11.2008 15:57:17 Uhr 14.11.2008 15:57:17 Uhr