EHEIM thermocontrol 25 Bedienungsanleitung Seite 13

English
‧ Danger of burning! The appliance is very hot during and directly
after operation. Never touch hot parts or the heating zone!
Commissioning
Installing the heater (⌦A)
1. Remove the transportation protection
2. Connect the suction device
3. Connect the suction device mount to the heater (not
4. Attach the appliance below water level on the inside
▶ The heater must be rinsed well in order to guarantee
▶ Only install the heater in a vertical position.
Operation
▶ Prior to the initial operation of the heater, place it in
Switching the heater on/off
1. Insert the mains plug in the mains socket. The control
2. To turn it off, remove the mains plug from the mains
Selecting a temperature (⌦B)
1. First, turn the adjusting ring
2. Set the desired temperature by turning the blue adjust-
▶ Check the water temperature at regular intervals.
Readjusting (⌦C)
If the adjusting scale does not correspond with the water
temperature after 1-2 days, the heater can be readjusted.
1. Measure the temperature with a precise thermometer.
2. Remove the mains plug from the mains socket.
3. Turn the red marking arrow
4. Set the desired water temperature with the blue
5. Insert the mains plug in the mains socket.
Before you remove the heater
WARNING! Burning and fire hazards due to hot
surfaces.
▶ Allow the appliance to cool down in the water for at
If you have accidentally removed the heater during
operation:
▶ Do not submerge the heater back into the water.
▶ Do not touch any hot surfaces.
▶ Remove the mains plug and allow the heater to cool
mount .
a
in the area of the heating zone
light ).
c
of your aquarium (⌦D). Take the minimum water level
and maximum immersion depth into account.
consistent water heating. Therefore, place the heater in
an area with a strong flow.
the water of your aquarium for 20-30 minutes without
turning it on.
light illuminates.
c
socket.
stop (18 °C or 65 °F).
ing ring. During the preheating process, the control light
will illuminate. The control light will turn off once the
c
set temperature has been reached.
that the thermometer measured.
adjusting ring.
least 30 minutes before removing it.
down for at least one hour on a heat-resistant base.
to the suction device
b
d
all the way back to the
f
to the water temperate
7
13
.
e
and the control