Technical Data - Renfert SILENT powerCAM TC Bedienungsanleitung

Trouble
The extraction unit • The connector to the CAM system or
does not respond to
the signals of the CAM
system.
• Interface cable damaged�
• Connector assignment of the interface
After switching on, not • The display that does not light up is
all displays light up
briefly.
8 Technical data
Nominal voltage:
Permissible mains voltage:
Mains frequency:
Power consumption *):
Mains input fuse:
LpA **) (at max. volume flow):
Ø suction port:
- inner
Volume flow, max. ***):
Vacuum pressure, max� ****):
Fine filter:
- Filter surface, approx�
- Filter quality
Fill volume dust drawer, approx�:
Weight (empty), approx�:
Dimensions (width x height x depth):
CAM interface:
Input signal:
- Low
- High
Output signal:
- Max� pull-up voltage (U)
- Max� switching current (I)
- Internal series resistance
*) Power consumption at nominal voltage
**) Noise level in accordance with EN ISO 11202
***) Free-blowing turbine at nominal turbine voltage
****) At nominal turbine voltage
Cause
the extraction unit is not correctly in-
serted�
cable does not match that of the CAM
system�
faulty�
• Check the connector on the extraction unit and CAM
system�
• Check the interface cable for damage, replace if re-
quired�
• Compare the connector assignment of the interface
cable with that of the CAM� Use a suitable interface
cable if required�
• Contact Renfert / Service�
SILENT powerCAM TC
2938 0000
230 V
220 - 240 V
50 / 60 Hz
850 W
42 mm [1�65 inches]
3980 l/min [2�34 ft³/s]
0�9 m² [1390 sq inch]
Class M in accordance with EN 60335-2-69
275 x 535 x 540 mm
[10�8 x 21�1 x 21�2 inches]
- 13 -
Corrective action
2938 1000
120 V
120 V
50 / 60 Hz
---
15 A (T)
54�3 dB(A)
281 hPa
[4�1 psi]
7 l
[1�85 US gal]
22�0 kg
[48�5 lbs�]
RJ45 port
0 - 5 V
15 - 24 V
24 V
5 mA
150 Ohm
en