Manual Mode; Shielding Gas Setup - Mahe MMS2000 Bedienungsanleitung

4.3.2. Manual mode

Fe CuSi
CrNi FC
Al Manual
4.3.2.1. Wire speed setup
AMP
4.3.2.2. Welding voltage setup
VOLT
%
4.4.

Shielding gas setup

For steel welding user can select between two shielding gases by following procedure:
switch off the machine with the main switch
-
press the encoder button in the AMP field
-
turn the main switch on while AMP encoder is
-
pressed
keep encoder pressed until the MIX or CO2 is
-
shown on the AMP display
release the encoder
-
by turning the encoder can be selected type of
-
used gas:
- Mixed gas 82%Ar + 18%CO2 (factory default)
- 100% CO2 gas
- to store preset value, press buttons
MMS2000C
Set up wire feed speed in m/min by turning the encoder.
Set up the welding voltage in Volts by turning the encoder.
and
AMP
simultaneously
EN
11