Welding Mode Selection / Manual Wire Inching; Welding Process Selection; Mig/Mag Welding Type Selection; Filler Wire Material Selection - Mahe MMS 2000P Bedienungsanleitung

4.2.2. Welding mode selection / Manual wire inching

(Not available if MMA/TIG selected)

4.2.3. Welding process selection

4.2.4. MIG/MAG welding type selection

(Not available if MMA/TIG selected)

4.2.5. Filler wire material selection

(Not available if MMA/TIG selected)
FeSg2 - Standard, not alloyed steel, shielding gas: 82%Ar + 18%CO
FeSg2 - Standard, not alloyed steel, shielding gas: 100%CO
308LSi - Stainless steel AWS308LSi, gas: 97.5%Ar + 2.5%CO
316LSi - Stainless steel AWS316LSi, gas: 97.5%Ar + 2.5%CO
309LSi - Stainless steel AWS316LSi, gas: 97.5%Ar + 2.5%CO
AlMg5 - Aluminum + 5% magnesium, shielding gas: 100%Ar
AlSi5
AlSi12 - Aluminum + 5% silicium, shielding gas: 100%Ar
CuSi3 - Copper silicium wire, shielding gas: 100%Ar
CuAl5 - Copper bronze wire, shielding gas: 100%Ar
SPEC1 – Custom specific wire (in case of special request)
SPEC2 – Custom specific wire (in case of special request)
MMS 2000P
MMS 2400
MMS 3000
- Two cycle mode
- four cycle mode
- Manual wire inch mode. In wire speed window is possible to
adjust the speed for manual feed. Feeding is activated by
pressing the trigger button.
- MIG/MAG process
- MMA welding process
-TIG welding with Lift Arc ignition
H
YPER
P
ULSE
H
H
YPER Y P E R
F
P
ORCE
U L S E
H
YPER
H
C
Y P E R
OLD
F
O R C E
H
Y P E R
C
O L D
- Aluminum + 5% silicium, shielding gas: 100%Ar
- Standard MIG/MAG welding
- Pulsed MIG welding
- MIG Double Pulse
- Hyper Pulse
- Hyper Force
- Hyper Cold
EN
2
2
2
2
2
13